SRP-382
Rev. 1.00
5-6-5 Preview
This application with a preview of a print-job runs, and windows driver does not directly
send print-job data to the printer when enabled by clicking “Enable Print Preview”. Print-
job data can be sent to the printer in the application.
The application supports a preview of a print-job including monochrome data. But
Greyscale data and data created by using device fonts or barcode fonts cannot be shown
in this application.
1) Tick Enable Print Preview to make Windows Driver ready for running the application.
2) When print-job data are created via Windows Driver, the application runs, and then
loads the data to draw the expected output on screen.
3) Click Print if you want to print, or click Close to exit the application.