41
VOLT:STEP? DEF command can query the step resolution of current for this unit. For example, a
step value of 0.01 represents 10 mV.
Command syntax: [SOURce:]VOLTage[:LEVel][:IMMediate]:STEP[:INCRement] <NRf>
Parameter: MIN to MAX
Query command: VOLTage:STEP?
Return parameter: <NRf>
Example: VOLT:STEP 0.01 //set the step value to be 0.01 V
VOLT UP //increments output current by 0.01 V
VOLT:STEP 0.02 //set the step value to be 0.02 V
VOLT DOWN //decrements output current by 0.02 V
[SOURce:]VOLTage[:LEVel]:TRIGgered[:AMPLitude]{<voltage level>|MINimum|MAXimum}
This command is used to set a voltage value to be triggered. This value will be set when the
instrument receives a trigger signal. Sending VOLTage command will not impact this command’s
voltage setting value. Sending a query command will return the original setting value.
Command syntax: [SOURce:]VOLTage[:LEVel]:TRIGgered[:AMPLitude] <NRf>
Parameter: MIN to MAX|MIN|MAX|DEF
Unit: V| mV| uV
Query syntax: [SOURce:]VOLTage[:LEVel]:TRIGgered[:AMPLitude]?
Return parameter: <NRf>
[SOURce:]VOLTage:PROTection[:LEVel]
This command is used to set the software-voltage protection value.
Command syntax: [SOURce:]VOLTage:PROTection[:LEVel] <NRf>
Parameter: MIN to MAX|MIN|MAX|DEF
Unit: V |mV| uV
Query syntax: [SOURce:]VOLTage:PROTection[:LEVel]?
Parameter: None
Return parameter: <NRf>
[SOURce:]VOLTage:PROTection:STATe
This command is used to set the software-voltage protection state.
Command syntax: [SOURce:]VOLTage:PROTection:STATe<bool>
Parameter: 0|1|ON|OFF
Query syntax: [SOURce:]VOLTage:PROTection:STATe?
Parameter: None
Return parameter: 0|1
VOLT:PROTection:TRIP?
This command is used to query the state of OVP. If the return value is “1”, this represents that
the OVP circuit has been triggered. If the return value is “0”, then the OVP circuit has not been
triggered.
Command syntax: [SOURce:]VOLTage:PROTection:TRIP?
Return parameter: 0|1
To Next Page
Loading...
Need help?
General
