40
Query syntax: [SOURce:]CURRent[:LEVel]:TRIGgered[:AMPLitude]?
Return parameter: <NRf>
[SOURce:]CURRent:PROTection[:LEVel]
This command is used to set the software-current protection value.
Command syntax: [SOURce:]CURRent:PROTection[:LEVel] <NRf>
Parameter: MIN to MAX|MIN|MAX|DEF
Unit: A |mA| uA
Query syntax: [SOURce:]CURRent:PROTection[:LEVel]?
Parameter: None
Return parameter: <NRf>
[SOURce:]CURRent:PROTection:STATe
This command is used to set the software-current protection state.
Command syntax: [SOURce:]CURRent:PROTection:STATe<bool>
Parameter: 0|1|ON|OFF
Query syntax: [SOURce:]CURRent:PROTection:STATe?
Parameter: None
Return parameter: 0|1
[SOURce:]VOLTage[:LEVel][:IMMediate][:AMPLitude]
This command is used to set the output voltage value.
Command syntax: [SOURce:]VOLTage[:LEVel][:IMMediate][:AMPLitude] <NRf>
Parameter: MIN TO MAX|MIN|MAX|DEF
Unit: V| mV| uV
Query syntax: [SOURce:]VOLTage[:LEVel][:IMMediate][:AMPLitude]?
Parameter: None
Return parameter: <NRf>
VOLTage {<volts>|MINimum|MAXimum|UP|DOWN|DEF }
This command is used to set the output voltage value. MIN represents 0 V and MAX represents
the max value of the voltage range. VOLT? MIN or VOLT? MAX commands are used to query the
minimum and maximum current of the range. DEF represents the default value and can also be
used to set the value. VOLT UP and VOLT DOWN commands and also be sent to increase or
decrease the current. The step value should be set with command “VOLT:STEP”.
Command syntax: [SOURce:]VOLTage[:LEVel][:IMMediate][:AMPLitude] <NRf>
Parameter: MIN to MAX|MIN|MAX|UP|DOWN|DEF
Unit: V|mV|uV
Query syntax: [SOURce:]VOLTage[:LEVel][:IMMediate][:AMPLitude]?; VOLTage?
[MINimum|MAXimum]
Return parameter: <NRf>
VOLTage:STEP {<value>|DEFault}
This command is used to set the step value for VOLT UP and VOLT DOWN commands.
To Next Page
Loading...
Need help?
General
