Luna
®
G3 APAP / Luna
®
G3 CPAP User Manual V1.0
24 / 48
WARNING!
• Do not touch the heater plate of the device when it is working, otherwise you may
get burned. Turn off the heat when the heated humidifier is not in use.
CAUTIONS!
• Generally speaking, the humidity inside the mask is low when the water
temperature is low.
• The greater the difference between the temperature inside the air tubing and
room temperature is, the more easily condensation occurs inside the tubing.
• If there are only a few condensed water droplets inside the tubing in the morning
after therapy, it means that the humidity level is appropriate; if there is lots of
condensed water droplets inside the tubing and / or mask, it means that the
humidity level is too high and should be set lower; Nasal dryness means that the
humidity level is too low and should be set higher.
15. Using the Cellular Module
The Luna
®
G3 APAP / Luna
®
G3 CPAP with a Cellular Module can wirelessly
communicate with the iCodeConnect. The iCodeconnect is intended to augment
the standard follow-up care of patients diagnosed with obstructive sleep apnea by
displaying usage and therapeutic information that has been transmitted from the
patient's Luna
®
G3 APAP / Luna
®
G3 CPAP therapy device to the clinician or
healthcare professional.
(1) Insert the Cellular Module into the device, and turn on the device. The device
screen displays the Main Screen shown in Fig. 15-1.
Fig. 15-1
(2) The Cellular Module starts searching for signals in a few seconds. Once a signal is
found, the module will automatically connect to it, and a signal icon will appear in
the status bar at the top of the device screen.
To Next Page
Loading...
Need help?
General
