Luna
®
G3 APAP / Luna
®
G3 CPAP User Manual V1.0
17 / 48
Fig. 12-8
(3) Connect the other end of the tubing to the mask according to the user manual
for the mask. Wear the mask.
WARNINGS!
• If you are using a mask with a built-in exhalation port, connect the mask’s
connector to the tubing.
• If you are using a mask with a separate exhalation port, connect the tubing to the
exhalation port. Position the exhalation port so that the vented air is blowing away
from your face. Connect the mask’s connector to the exhalation port.
• If you are using a full-face mask (a mask covering both your mouth and nose), the
mask must be equipped with a safety (entrainment) valve.
• In order to minimize the risk of CO
2
rebreathing, the patient should observe the
following instructions:
- Use only tubing and mask provided by 3B MEDICAL.
- Do not wear the mask for more than a few minutes while the device is not
operating.
- Use only masks with vent holes. Do not block or try to seal the vent holes in the
exhalation port.
12.5 Using Oxygen with the Device
Oxygen may be added at the mask connection. Please observe the instructions
listed below when using oxygen with the device.
WARNINGS!
• Connect the oxygen tube to the oxygen inlet of the mask.
• The oxygen supply must comply with the local regulations for medical oxygen.
• Turn on the device before turning on the oxygen. Turn off the oxygen before
turning off the device. Explanation of Warning: When the device is turned off, but
the oxygen flow still exists, oxygen may accumulate within the device's enclosure
and pose a fire hazard. Turning off the oxygen before turning off the device will
prevent oxygen accumulation in the device and reduce the risk of fire. This warning
applies to CPAP devices.
• Oxygen supports combustion. Keep the device and the oxygen container away
To Next Page
Loading...
Need help?
General
