Fig. 12-4
Note: The length of the power cord and power adapter is 1.5 m and 1.8 m
respectively without the function of preventing electromagnetic interference.
WARNINGS!
• The device is powered on for use when the power cord and power adapter is
connected. The Knob turns the blower On / Off.
• Use of the device at an AC voltage beyond the stated range (see Section 5 “AC
Power Consumption”) may damage the device or cause device failure.
• Connect to appropriate power for proper operation of the device.
• Inspect the power cord often for any signs of damage. Replace a damaged cord
immediately.
IMPORTANT TIPS!
• After interruption and restoration of the power supply, the device will restore its
pre-interruption working status automatically.
• To remove AC power, disconnect the power cord from the power outlet.
12.4 Assembling the Tubing / Heated Tubing and Mask
(1) Connect one end of the tubing to the air outlet of the device, as shown in Fig.
12-5.
To Next Page
Loading...
