Luna
®
G3 APAP / Luna
®
G3 CPAP User Manual V1.0
36 / 48
(2) Install the filter cap containing the air filter to the device, as shown in Fig. 18-8.
Fig. 18-8
(3) Disassemble the PM2.5 Filter from the device, as shown in Fig. 18-9, then change
a new one.
Fig. 18-9
CAUTIONS!
• To avoid material damage, do not place the spare air filter / PM2.5 Filter in direct
sunlight, humid environments, or temperatures below the freezing point. The air filter
/ PM2.5 Filter should be replaced every 6 months (It may be replaced more
frequently based on actual sanitary conditions).
• Operating the device with a dirty air filter may stop it from working properly and
may cause damage to the device.
19. Traveling with the Device
(1) Use the 3B MEDICAL carrying case to carry the device and accessories along
with you. Do not put them in your checked baggage.
(2) This device operates on power supplies of 100 - 240 V and 50 / 60 Hz, and is
suitable for use in any country in the world. No special adjustment is necessary, but
you will need to find out the types of the power sockets in your destination. Bring, if
necessary, a power socket adaptor which can be purchased in electronics stores.
(3) Remember to bring a spare air filter and the emergency documents (filled and
signed by your physician) about this device. If you plan to travel by air, remember to
bring the multi-language emergency documents about respiratory therapy, in case
that the border and customs officers in your destination country inspect the device.
With the emergency documents, you can prove to them that it is a medical device.
To Next Page
Loading...
Need help?
General
