BMC 3B Luna G3 APAP

Luna
®
G3 APAP / Luna
®
G3 CPAP User Manual V1.0
44 / 48
Guidance and manufacturer's declaration - electromagnetic immunity
The device is intended for use in the electromagnetic environment specified
below. The user of the device should make sure that it is used in such an
environment.
Immunity
Test
IEC 60601 Test
Level
Compliance
Level
Electromagnetic Environment -
Guidance
Conducte
d RF
IEC
61000-4-6
Radiated
RF
IEC
61000-4-3
3 V
0.15 MHz ～
80 MHz
6 V in ISM and
amateur radio
bands
between
0.15 MHz and
80 MHz
10 V/m
80 MHz to 2.7
GHz
3 V
0.15 MHz ～
80 MHz
6 V in ISM and
amateur radio
bands
between
0.15 MHz and
80 MHz
10 V/m
80 MHz to 2.7
GHz
Portable and mobile RF
communications equipment
should be used no closer to any
part of the device, including
cables, than the
recommended separation
distance calculated from the
equation applicable to the
frequency of the transmitter.
Recommended separation
distance
pd 17.1=
pd 35.0=
80 MHz to 800 MHz
pd 70.0=
800 MHz to 2.5 GHz
Where p is the maximum output
power rating of the transmitter
in watts (W) according to the
transmitter manufacturer and d
is the recommended
separation distance in meters
(m).
Field strengths from fixed RF
transmitter, as determined by
an electromagnetic site survey,
a
should be less than the
compliance level in each
frequency range.
b
Interference may occur in the
vicinity of equipment marked
with the following symbol:
Note 1: At 80 MHz and 800 MHz, the higher frequency range applied.
Note 2: These guidelines may not apply in all situations. Electromagnetic
propagation is affected by absorption and reflection from structures, objects and
people.
a
Field strengths from fixed transmitters, such as base stations for radio (cellular /
cordless) telephones and land mobile radios, amateur radio, AM and FM radio
broadcast and TV broadcast cannot be predicted theoretically with accuracy.
To assess the electromagnetic environment due to fixed RF transmitters, an
electromagnetic site survey should be considered. If the measured field strength
in the location in which the device is used exceeds the applicable RF
compliance level above, the device should be observed to verify normal
operation. If abnormal performance is observed, additional measures may be
necessary, such as re-orienting or relocating the device.
b
Over the frequency range 150 kHz to 80 MHz, the field strengths should be less
than 10 V/m.