BMPRO JAYCOMMAND User Manual

PAIRING TO THE NODE
Pairing your CONTROLLER, smartphone or tablet to the NODE is done in three
easy steps. The APP will guide you through the pairing process.
NOTE: The CONTROLLER will have been paired to your NODE at the factory. You
should only need to pair your own device or smartphone to the NODE.
While the NODE can be paired to a total of four devices (including the
CONTROLLER), you can only pair one device at a time to the NODE.
1. Launch the APP on your phone.
2. Using the < or > button on the CONTROLLER, navigate to the ‘PA’ menu item.
3. When ‘PA’ appears on the display, press the EXT button to start the pairing
process to the NODE. ‘PA’ will blink for a maximum of 30 seconds or until a
device is connected.
Use < or > to navigate to the 'PA' menu item
Figure 4: Press EXT once, to start the pairing process
14

BMPRO JAYCOMMAND Specifications

General

Brand	BMPRO
Model	JAYCOMMAND
Category	Controller
Language	English