CANNOT PAIR TO THE NODE
If you are pairing a mobile device to the NODE and "--" appears on screen, it is
mostly likely that four devices are connected to the NODE simultaneously. To
resolve this, either:
• Close the app on one of the devices that are connected to the NODE and try
again, OR
• Clear the memory of the NODE of all the previously paired devices.
Figure 5: Failed to connect
WARNING
Clearing the NODE memory will also clear the pairing between the NODE &
CONTROLLER. After clearing, the CONTROLLER will need to be paired to the NODE again.
CLEARING NODE OF ALL PREVIOUSLY PAIRED DEVICES
1. Go to the APP General Settings and press Bluetooth Connection.
2. Press Unpair RV to unpair the CONTROLLER from the NODE.
Figure 6: Unpairing a mobile device from the NODE
15
To Next Page
Loading...
