5. Pair the CONTROLLER to the NODE again.
See Pairing to the NODE.
6. Pair the new device to the NODE.
See Pairing to the NODE.
Figure 7: Go to PA, then Press and hold EXT until the number 1 scrolls across the CONTROLLER
3. Navigate to the PA function on the CONTROLLER display.
4. Press and hold EXT until the number 1 scrolls across the CONTROLLER
display. The NODE is now clear of all connected devices.
5. When pairing is successful, you will be taken to the APP home screen and the
Bluetooth icon will be visible.
CONGRATULATIONS, YOU’RE CONNECTED!
Figure 8: CONTROLLER Home screen after pairing successful
For any additional support, see FAQs & Troubleshooting.
16
To Next Page
Loading...
