BMPRO JAYCOMMAND User Manual

SWITCH
The SWITCH communicates via Bluetooth to the NODE, giving you additional
control of RV features.
NOTE: Any SWITCH you install in your RV has been paired to the NODE at the
factory and is ready for immediate use.
CHECKING THE BATTERY IN YOUR SWITCH
The SWITCH is powered by a standard 3V Lithium Cell coin battery (CR2032).
You can check if the battery needs replacing from the APP General Settings.
Open the Battery Levels page in the General Settings screen then press any
button on the SWITCH you are checking. Once the button has been pressed,
the APP will refresh with the switch battery status.
Figure 40: Battery Powered Wall Switches Settings.
LOW indicates that the battery in the wall switch needs replacing.
REPLACING THE BATTERY IN YOUR SWITCH
To replace the battery, unclip the SWITCH
Button Pad. Using a flathead screwdriver, pry
open the SWITCH Button Pad and remove the
battery from the holder. Insert the new battery
in the holder with the positive side facing up.
Figure 41: Accessing the
battery in the SWITCH
42

BMPRO JAYCOMMAND Specifications

General

Brand	BMPRO
Model	JAYCOMMAND
Category	Controller
Language	English