IMPORTANT
Never clean the Wallbox using a jet of water (hosepipe, pressure washer, etc.)!
Ensure that the Wallbox is not damaged by incorrect handling (housing cover, internal parts,
etc.).
If it is raining or snowing and the Wallbox is installed outdoors, do not open the terminal
panel cover.
Risk of breakage of the plastic housing!
- No countersunk screws may be used for mounting!
- Do not use force to tighten the fastening screws.
- The mounting surface must be completely flat (max. 1 mm difference between the
support or attachment points). Deflection of the housing must be avoided.
Instructions for trained personnel authorised to open the device:
Danger of damage. Electronic components may be destroyed if touched.
Before handling modules, perform an electrical discharge process by touching a metallic
earthed object.
A failure to follow the safety information may result in a danger of death, injury or damage to the
device! The device manufacturer cannot accept any liability for claims resulting from this!
10
To Next Page
Loading...
