BMW R1200RT - Page 40

pressure adjustment in the chap-
ter "Technology in detail".
Have the tire checked for dam-
age at an authorized service
facility, preferably an authorized
BMW Motorrad retailer.
If you are unsure about the tire's
suitability for continued riding:
Do not continue riding.
Contact roadside service.
Transmission error
with Tire Pressure Control
(TPC/RDC)
OE
+ "--" or "-- --" is indi-
cated.
Possible cause:
The motorcycle has not reached
the minimum speed ( 110).
RDC sensor is not active
min 19 mph (min 30 km/h)
(The RDC sensor does not
transmit a signal to the motor-
cycle until this minimum speed
has been exceeded.)
Watch the RDC display at
higher speed. A continuous
error is only present if the
general warning lamp also
lights up. In this case:
Have fault eliminated at a spe-
cialist service facility, preferably
an authorized BMW Motorrad
retailer.
Possible cause:
There is a fault in the radio con-
nection to the RDC sensors.
Possible causes are radio sys-
tems in the surrounding area,
which interfere with the connec-
tion between the TPC/RDC con-
trol unit and the sensors.
Observe the RDC display in a
different environment. A con-
tinuous error is only present if
the general warning lamp also
lights up. In this case:
Have fault eliminated at a spe-
cialist service facility, preferably
an authorized BMW Motorrad
retailer.
Sensor defective or
system error
with Tire Pressure Control
(TPC/RDC)
OE
shows yellow.
+ "--" or "-- --" is indi-
cated.
Possible cause:
Wheels without RDC sensors are
mounted.
Retrofit wheel set with RDC
sensors.
3
38
z Displays