Hill Start Control is auto-
matically deactivated after
pulling away.
The general warning light
and the indicator lamp on the
display light up briefly and then
the Hill Start Control indicator
lamp goes out when the brake
is fully released.
Hill Start Control is now
switched off.
Tires
Check tire pressure
Incorrect tire inflation pres-
sure results in poorer hand-
ing characteristics of the motor-
cycle and reduces the life of the
tires.
Ensure proper tire inflation
pressure.
At high road speeds, tire
valves installed perpen-
dicular to the wheel rim have a
tendency to open as a result of
centrifugal force.
Use valve caps with rubber seals
and screw them on firmly to pre-
vent sudden tire deflation.
Make sure ground is level and
firm and park motorcycle.
Check tire pressures against
data below.
Tire pressure, front
36.3 psi (2.5 bar) (with tire
cold)
Tire pressure, rear
42.1 psi (2.9 bar) (with tire
cold)
If tire pressure is too low:
Correct tire pressure.
Heating
Operating heated grips
Start engine.
The heated grips option
can only be activated when
the engine is running.
Open the Handle heat.
menu.
The grips have five-stage heat-
ing. Stage five is for heating the
grips quickly: it is advisable to
switch back to a lower stage as
soon as the grips are warm.
4
72
z
Operation
To Next Page
Loading...
