6
C/ Type C support (ref. 915173)
• Pour two blocks of concrete for the two posts with the help of the jigs (915193).
• Seal the 8 anchor bolts (915178) in each block (4 bolts per block) and then tighten the nuts.
Make sure you carefully check the spacing and height of the anchor bolts.
The volume of the blocks is to be calculated in accordance with the nature of the terrain and the wind exposure of the
board.
B
Rigid insulating tube and clips
to be assembled on site
Rigid insulating PVC tube Ø20
Plate edge clips
Upright post
B
Nut HU M16
Bent anchor bolt M16
A
Flat washer M16
2000
180180
4500
A
320
160
To Next Page
Loading...
General