9
7. Sync LED Indicator
Solid green - Dante network clock follower sync to leader achieved
Blinking green - Dante network clock leader
Amber - Syncing in progress
Red – sync error
Off - No power
8. HDCP LED Indicator
Solid green - Non HDCP unprotected video sink or source detected
Blinking green - HDCP protected content detected
Solid red - Invalid non-HDCP video sink or source
Blinking red - Failed HDCP negotiation
Blinking Amber - HDCP negotiation in progress
Off - No power
9. RS-422 Control Port
Use the included RJ45 to RS422 extension cable to connect an RS422 controller or control system.
Refer to RS422 Interface (Page 19) for more information.
10. 3.5mm IR in for External IR Receiver Connection
11. USB OTG
USB On The Go (OTG), reserved
12. USB 1 Port
Used to connect a keyboard
13. USB 2 Port
Used to connect a mouse
NOTE:
• The USB ports can only be used for keyboard and mouse connections - USB flash drives / hard drives
are not supported.
• Connect a USB cable (male type A USB to male mini-USB) from a USB port on a PC to the USB OTG
port of a Dante AV Encoder. When properly configured, the keyboard and/or mouse connected to the
Dante AV Decoder end can be used to control the PC connected at the Encoder location.
14. Screw Hole
15. Vents
16. 12G-SDI output (Apply for D20S Only). It is a cover on the D20H.
D20S is equipped with 12G-SDI interface, it is reserved when D20S used as an encoder
17. Monitor Output
Hardware loop-out for encoder HDMI In input signal
18. HDMI In
Encoder HDMI signal input interface
19. HDMI Output
Reserved when D20H and D20S used as an encoder
20. LAN Port
RJ45 port for Ethernet connection, does not support POE power supply
21. LAN/POE++(IEEE802.3bt) for Dante Video Input
22. 12V DC Power Port
Connect the supplied DC power adaptor and cord.
23. Screw holes for HDMI cable secure mount
To Next Page
Loading...