111
BREAK-IN PERIOD
Engine
Quest MAX and Traxter MAX Series
A break-in period of 10 operating hours
is required before running the vehicle
at sustained full throttle.
CAUTION: Never mix oil with fuel.
This vehicle has a 4-stroke engine.
Oil must be added to engine base
only.
During this period, maximum throttle
should not exceed 3/4. However, brief
full acceleration and speed varia-
tions contribute to a good break-in.
Continued wide open throttle acceler-
ations, prolonged cruising speeds and
engine overheating are detrimental
during the break-in period.
Belt
Quest MAX Series
A new belt requires a break-in period of 50
km (30 miles). Avoid strong acceleration/
deceleration, pulling a load or high speed
cruising.
10-Hour Inspection
Quest MAX and Traxter MAX Series
As with any precision piece of me-
chanical equipment, we suggest that
after the first 10 hours or 30 days after
the purchase, whichever comes first,
your vehicle be inspected by an autho-
rized Bombardier ATV dealer. This in-
spection will give you the opportunity
to discuss the unanswered questions
you may have encountered during the
first hours of operation.
While reading this Operator’s Guide, remember that:
The 10-hour inspection is at the ex-
pense of the vehicle owner.
WARNING
Indicates a potential hazard that, if not avoided, could result in serious
injury or death.
vmo2004_011a.book Page 111 Thursday, May 15, 2003 1:46 PM
To Next Page
Loading...
Need help?
General
