BOMBARDIER Traxter Max XT 2004 User Manual

89
R: Reverse
This allows the vehicle to go backward.
The vehicle speed is limited.
N: Neutral
This position disengages the transmis-
sion to allow manual vehicle move-
ment or towing.
H: High gear
This selects the high speed range of
the transmission in the gear box. It is
the normal riding position. It allows the
vehicle to reach its maximum speed.
L: Low gear
This selects the low speed range of
transmission in the gear box. It is the
working position. It allows the vehicle
to move slowly with the maximum
traction and power.
NOTE: Use the low speed range to
pull any load or to climb a steep slope.
6) Multi-Function Switch
Quest MAX Series
The multi-function switch is located on
the left side of handlebar.
1. Multi-function switch
The controls located on this multi-
function switch are:
Headlamp Switch
Located on the top of multi-function
switch. Place headlamp switch to LO
for the low beam and taillight. Place
headlamp switch to HI for the high
beam and taillight.
1. Headlamp switch
2. Low beam position
3. High beam position
NOTE: Place ignition switch to ON
“without light” position to close the
headlamp.
ON POSITION “WITHOUT LIGHT”

WARNING
Before moving vehicle in reverse,
ensure the path behind is clear of
obstacles or bystanders. Remain
seated.
V04I0BY
1
V04K0L0
1 2
3
V04I0CY
vmo2004_011a.book Page 89 Thursday, May 15, 2003 1:46 PM

BOMBARDIER Traxter Max XT 2004 Specifications

General

Brand	BOMBARDIER
Model	Traxter Max XT 2004
Category	Offroad Vehicle
Language	English