113
OPERATING INSTRUCTIONS
General
Quest MAX and Traxter MAX Series
Transmission lever must be on PARK
or NEUTRAL to allow engine starting.
For your convenience, an override
mode allows to start the engine with
the transmission lever in any position.
Press and hold the front or rear brake
lever or the brake pedal while pressing
the start button.
Quest MAX Series
To start engine, place the engine stop
switch to RUN position, insert key in
ignition switch and turn to ON then
press start button.
Traxter MAX Series
The engine can be started in any gear
(from 1 to 5).
To start engine, insert key in ignition
switch and turn to ON then press the
start/stop switch.
Initial Cold Starting
Quest MAX and Traxter MAX Series
Insert key in ignition switch and turn to
ON.
In cold weather, colder than 0°C (32°F),
place the choke lever in full position.
QUEST MAX SERIES
1. Full choke position
TRAXTER MAX SERIES
1. Full choke position
1
V04I0FZ
V01I18Z
1
vmo2004_011a.book Page 113 Thursday, May 15, 2003 1:46 PM
To Next Page
Loading...
Need help?
General
