126
MAINTENANCE
While reading this Operator’s Guide, remember that:
The following covers the maintenance
items that can be performed by the cus-
tomer if desired. Other items found in
maintenance chart must be performed
by an authorized Bombardier ATV dealer.
NOTE: Among other things, this sec-
tion gives the procedures to replace
the liquids. Refer to LIQUIDS for pro-
cedures to check levels and refill.
Engine/Transmission
Quest MAX and Traxter MAX Series
Oil Change and Oil Filter
Replacement
Oil and filter are to be replaced at the
same time. Oil change should be done
with a warm engine.
Ensure vehicle is on a level surface.
Clean the drain plug area.
Remove dipstick.
Place a drain pan under the engine drain
plug area.
Unscrew drain plug.
QUEST MAX SERIES
1. Oil drain plug
WARNING
Indicates a potential hazard that, if not avoided, could result in serious
injury or death.
WARNING
Unless otherwise specified, en-
gine should not be running for all
maintenance procedures.
Before performing any service or
inspection operation on the vehi-
cle, wait until the engine and ex-
haust have cooled down to avoid
potential burns.
WARNING
Should removal of a locking device
(e.g. lock tabs, self-locking fasten-
ers, etc.) be required when under-
going disassembly/assembly, al-
ways replace with a new one.
WARNING
The engine oil can be very hot.
Wait until engine oil is warm.
V04C07Y
1
vmo2004_011a.book Page 126 Thursday, May 15, 2003 1:46 PM
To Next Page
Loading...
Need help?
General
