125
➀ To be performed by an authorized Bombardier ATV dealer. The initial mainte-
nance is very important and must not be neglected.
➁ Every 100 hours, check coolant strength.
➂ More often under severe use such dusty area, sand, snow, wet or muddy conditions.
➃ Pre-ride inspection item.
➄ Must be performed by an authorized Bombardier ATV dealer.
I: Inspect, verify, clean, adjust, lubricate, replace if necessary
C:Clean
L: Lubricate
R: Replace
INITIAL 10 h
INSPECTION
OR 250 km (150 m.) ➀
EVERY
TO BE
PERFORMED BY
25 h
OR 625 km (388 m.)
50 h
OR 1250 km (777 m.)
100 h OR 1 YEAR
OR 2500 km (1553 m.)
200 h OR 2 YEARS
OR 5000 km (3107 m.)
STEERING/CONTROL SYSTEMS
Handlebar fasteners I Dealer
Throttle/housing/cable ➃ II Customer
Choke condition ➃ II Customer
Steering system IIDealer
Tie rod ends I Dealer
Wheel nuts/studs II Customer
Wear/pressure of tires ➃ EVERY RIDE Customer
Front wheel alignment IIDealer
SUSPENSION
Swing arm ➃ I Dealer
Shock absorber ➃ I Dealer
A-arm lubrication I Customer
BRAKE
Brake fluid front/rear ➃ II R
➄
Customer
Brake cable II Dealer
Brake pad I Customer
Brake system (discs, hoses etc.) I Customer
BODY/FRAME
Engine compartment CC Customer
Skid plate EVERY RIDE Customer
Frame I Dealer
Hitch/trailer ball condition (if installed) II Customer
Chassis fasteners I Customer
Seat fasteners EVERY RIDE Customer
Backrest EVERY RIDE Customer
Grab handles EVERY RIDE Customer
Front storage compartment cover/seat latches ➃ I Customer
Vehicle cleaning and protection C Customer
vmo2004_011a.book Page 125 Thursday, May 15, 2003 1:46 PM
To Next Page
Loading...
Need help?
General
