118
ATV Immersion
Quest MAX and Traxter MAX Series
Should the ATV become immersed, it
will be necessary to take it to an autho-
rized Bombardier ATV dealer as soon
as possible. DO NOT START THE EN-
GINE! Immersion of the ATV can cause
serious damage if the correct restart
procedure is not followed.
Post-Operation Care
Quest MAX and Traxter MAX Series
When vehicle is used in salt-water envi-
ronment (beach area, launching/loading
boats etc.), rinsing the vehicle with fresh
water is necessary to preserve vehicle
and its components. Metallic parts lubri-
cation is highly recommended. Use
BOMBARDIER LUBE (P/N 293 600 016).
This must be performed at the end of
each operating day.
When vehicle is operated in muddy
conditions, rinsing the vehicle is rec-
ommended to preserve vehicle and its
components and to keep lights clean.
Emergency Shifter
Traxter MAX Series
If the shifting system is not operation-
al, you may use the emergency shifter.
It allows transmission gear change
when the vehicle is not in motion. You
set the desired gear once then go back
home while the transmission remains
in this gear. No gear change can take
place since the shifting system is not
operational. The shifter shaft end is lo-
cated on rear side of engine.
Place transmission on PARK position.
Remove seat.
Use the special key in the tool box to
rotate the emergency shifter. Open
the tab of the tool approximately at a
right angle (90°). Insert the screwdriv-
er included in the tool box at the end
of the special tool so that it can be
used as a handgrip.
1. Insert the screwdriver here as a handgrip
A. Open tab at a right angle (90°)
Insert the tool to the end of the shifter
shaft.
1. Emergency shifter shaft. Insert special tool
here
WARNING
The exhaust pipe can be very hot.
Wear gloves and/or allow exhaust
pipe to cool.
V01B02Y
1
A
V01C22Y
1
vmo2004_011a.book Page 118 Thursday, May 15, 2003 1:46 PM
To Next Page
Loading...
Need help?
General
