AMAX panel 2000 / AMAX panel 2000 EN User Guide | en 27
Bosch Sicherheitssysteme GmbH Installation Manual F.01U.241.127 | V4 | 2011.12
4.7.2 Bypassing Faults and Tamper conditions (Except Zone Tampers)
Bypassing Faults and Tamper conditions, one or more faults and tamper conditions are
disabled for one arming cycle. After bypassing a Fault or Tamper condition, you can arm the
system even when a Fault or Tamper condition exists.
How to bypass faults and tamper conditions
1. Enter your user code + [97] and press [#].
Two beeps sound.
4.8 Enable / Disable the installers code
This function allows user code holder to enable or disable the installer code.
Installer can only perform actions when he is enabled by a user.
1. Enter your user code + [98] and press [#] to enable the function.
Two beeps sound.
2. Enter your user code + [98] and press [*] to disable the function.
Two beeps sound.
4.9 Change individual code
This function allows user to change their individual code.
How to change the code
1. Enter your code and press [99] [#].
Two beeps sound and the STAY and AWAY indicators flash, and your user number is
shown on the keypad.
2. Enter the new code and press [#].
Two beeps sound and the STAY and AWAY indicators are extinguished.
4.10 Keypad alarm operation commands
4.10.1 Duress alarm
A keypad duress alarm is used as a silent holdup alarm when 0 is added to the end of a valid
Code used to disarm the system ( [code] + [0] + [#] ).
A duress alarm is useful only if your system reports to a monitoring station. Domestic
reporting cannot define the type of alarm that occurred.
4.10.2 Keypad panic alarm
If you simultaneously press and hold [1] and [3] or simultaneously press and hold [*] and [#],
a silent emergency alarm will be transmitted. Please contact your installer to enable/disable
the keypad emergency alarm functionality.
Simultaneous pressing and holding the wireless remote control key arming and disarming key
can also transmit a wireless emergency alarm.
4.10.3 Keypad fire alarm
If you simultaneously press and hold [4] and [6], a silent keypad fire alarm will be transmitted.
Please contact your installer to enable/disable the fire alarm functionality.
NOTICE!
This function is automatically terminated if you do not press a button within 240 seconds or if
you press [#]. One long beep indicates that the code already exists or that you entered an
incorrect user number.
To Next Page
Loading...
