AMAX panel 2000 / AMAX panel 2000 EN System Functions | en 39
Bosch Sicherheitssysteme GmbH Installation Manual F.01U.241.127 | V4 | 2011.12
6 System Functions
6.1 Duress alarm
This function allows code holders to perform a keypad Duress Alarm.
A Keypad Duress Alarm is used as a silent holdup alarm when 0 is added to the end of a valid
Code used to disarm the system.
User
Code
Install
er
Code
Function Description
• • 0 # Duress alarm (Refer to 6.1 )
• • 1 # Siren test (Refer to 6.2 )
• • 2 # Fault and Tamper analysis (Refer to 6.3 )
• • 3 # View date and time (Refer to 6.4 )
• • 4 # Walk test (Refer to 6.5 )
• • 5 # Event memory recall (Refer to 6.6 )
• • 6 # Reset panel/clear siren (Refer to 6.7 )
• • 7 # Initiate a modem call (Refer to 6.8 )
• • 8 # Send Test report (Refer to 6.9 )
• • 9 # Bypass (inhibit) (Refer to 6.10 )
• • 96 # Show Zone type (Refer to 6.11 )
• 97 # Bypass all faults (Refer to 6.12 )
•98#
*
Enable=# / Disable=* installer code user's access (Refer to
6.13 )
• • 99 # Change individual code (Refer to 6.14 )
• 955 # Change/View date and time (Refer to 6.15 )
• 956 # Add/delete a level 2 user (Refer to 6.16 )
• 956 # Add/delete Remote Radio User Codes (Refer to 6.17 )
• 957 # Change domestic phone numbers (Refer to 6.18 )
• 958 # Enter Programming Mode (Refer to 6.19 )
• 959 # Exits from installer’s programming mode without saving
the programmed data. (Refer to 6.20 )
• 960 # Exits from installer’s programming mode with saving the
programmed data. (Refer to 6.21 )
• 961 # Resets the control panel to factory defaults. (Refer to
6.22 )
• 962 # Copies the control panel memory to the programming key.
(Refer to 6.23 )
• 963 # Copies the programming key data to the control panel
memory. (Refer to 6.24 )
• 999 # Displays the software version number or control panel
type. (Refer to 6.25 )
Default Pads on PCB Default the control panel with the hardware (Refer to
6.26 )
To Next Page
Loading...
