30 en | Fault and Tamper Description AMAX panel 2000 / AMAX panel 2000 EN
F.01U.241.127 | V4 | 2011.12 Installation Manual Bosch Sicherheitssysteme GmbH
Zone Indicator
5.1 Accessory Modules Fail
The zone indicator 1 lights to indicate external module fail.Enter [1] to step to external
modules fail list for more information.
5.1.1 Keypad 1 fail
Condition:
1. Keypad fail is reported at any time when communication fails between the panel and
address 1 keypad.
Restore:
Communication between panel and keypads comes back to normal and fault is reset.
Supervise:
1 Accessory Modules Fail ( Refer to 5.1 )
1 Keypad 1 fail (Refer to 5.1.1 )
2 Keypad 2 fail (Refer to 5.1.2 )
3 DX 3010 Fail (Refer to 5.1.3 )
4 B420/DX 4020 /-G Fail (Refer to 5.1.4 )
2 Power Faults (Refer to 5.2 )
1 AC Fault (Refer to 5.2.1 )
2 Fault Battery (Refer to 5.2.2 )
3 Aux Power Supply Fault (Refer to 5.2.3 )
4 Bosch Option Bus Power Fault (Refer to 5.2.4 )
5 RF Power Fault (Refer to 5.2.5 )
3 Warning Device Failure List (Refer to 5.3 )
1 Warning Device 1 Disconnected (Refer to 5.3.1 )
2 Warning Device 1 Short (Refer to 5.3.2 )
3 Warning Device 2 Disconnected (Refer to 5.3.3 )
4 Warning Device 2 Short (Refer to 5.3.4 )
4 Telephone Line Fail (Refer to 5.4 )
5 Date and Time Fail (Refer to 5.5 )
6 Communications failure (Refer to 5.6 )
1 Communication Failure 1 (Refer to 5.6.1 )
2 Communication Failure 2 (Refer to 5.6.2 )
3 Communication Failure 3 (Refer to 5.6.3 )
4 Communication Failure 4 (Refer to 5.6.4 )
7 Tamper (Refer to 5.7 )
1 On board Tamper (Refer to 5.7.1 )
2 Keypad 1 Tamper (Refer to 5.7.2 )
3 Keypad 2 Tamper (Refer to 5.7.3 )
4 Keypad Lock out (Refer to 5.7.4 )
5 Sensor Tamper (Refer to 5.7.5 ) (Zone 1-8)
6 Tamper Zone (Refer to 5.7.6 ) (Zone 1-8)
8 External Fault (Re
fer to 5.8 )
To Next Page
Loading...
