7 Jumper: Equalization of potential between different
systems and earth ground (shield)
8 Jumper: Interface selector RS-485 host connection,
RS-485 two wire or RS-485 four wire (depends on
external wiring)
9 Configurable RS-485 host interface
10 Docking port for compact flash memory
11 Configurable RS-232 host interface (ribbon cable
connector)
12 Configurable 10/100 Mbit/s Ethernet host interface
Figure 3.4: Overview - Interfaces
13
RS-485 extension module bus
14 External tamper contact
15 Connector for power supply
16 Wiegand interfaces for up to 4 card readers
Access Modular
Controller
Introduction | en 15
Bosch Sicherheitssysteme 2016-11 | AMC2-4W |
To Next Page
Loading...
