Ethernet Host Interface
The AMC2-4W offers a 10/100 Mbit/s Ethernet auto-sensing
interface to connect to a local area network or host computer.
Notice!
Use either a CAT5 crossover cable to connect the AMC2-4W
directly to host computer, or a standard CAT5 patch cable to
connect the AMC2-4W via a network.
A complete connection diagram of the Ethernet host interface is
shown in chapter Connecting Diagrams, page 60.
Figure 4.8: Location of the Ethernet interface
Notice!
After connecting a new AMC2 device to a network using DHCP,
it can take some time before the new AMC2 device is
recognized by the remote server.
You can accelerate this process by running the following
command:
ipconfig /flushdns
This makes the AMC2 device immediately available by its name.
4.8
30 en | Installing
Access Modular
Controller
2016-11 | AMC2-4W | Bosch Sicherheitssysteme
To Next Page
Loading...
