Bosch AMC2-4W - Performance Characteristics

17 Connectors for eight analog inputs
18 Connectors for eight relay outputs
Notice!
All connectors, with the exception of the RS-232 and Ethernet
host interface, are pluggable screw clamp terminals.
Figure 3.5: Jumper at the bottom side
19
Jumper for setting either voltage free relay output (“dry”
mode) or looped-in voltage from the AMC2 internal
power supply (“wet” mode).
20 Jumper: Equalization of potential between different
systems and earth ground (shield) for the extension
interface.
Performance Characteristics
– Intelligent access manager for 1 - 4 entrances (for example
doors, man traps, barriers)
– Host address selectable using DIL sliding switch.
– Four possible configurable host interfaces:
– Ethernet (= standard)
– RS-485 2-wire
– RS-485 4-wire
3.3
16 en | Introduction
Access Modular
Controller
2016-11 | AMC2-4W | Bosch Sicherheitssysteme