Bosch AMC2-4W - Unmounting the Controller

Unmounting
Notice!
To remove the AMC2-4W from a mounting rail, first remove all
pluggable connectors.
Push down the AMC2-4W until the lower edge snaps out of the
mounting rail [1]. Pull the lower end of the AMC2-4W from the
mounting rail [2].
Figure 4.2: Unmounting the AMC2 from a mounting rail
4.2
Access Modular
Controller
Installing | en 21
Bosch Sicherheitssysteme 2016-11 | AMC2-4W |