Bosch B4512 - Rps

26.4 RPS
Use the RPS menu for connection to Remote Programming
Software (RPS). Your security company uses RPS to configure
and service your security system. RPS is intended for use by
professional or licensed installers only.
26.4.1 Answer
Use the Answer option to answer the phone (pick up the phone
line) to connect to RPS.
Using the Answer menu option to answer an incoming call from
RPS:
1. Open the Main menu.
2. Use [NEXT] to go to the Actions menu option, and press
[ENTER], or simply press [3].
3. Use [NEXT] to go to the RPS menu option, and press
[ENTER], or simply press [4].
4. Press [1] or [ENTER] to reset the sensors with the Answer
option.
5. Enter your passcode and press [ENTER]. The keypad shows
RPS is connecting…. and then returns to idle text.
Control Panels B92x/B91x Actions menu | en 161
Bosch Security Systems, Inc. 2015.01 | 02 | F.01U.307.371