6 How the system reports events
Your security system makes repeated attempts to send reports to
your security company. In the event your security system fails to
communicate, the keypad sounds the trouble tone and the
keypad shows a communication failed message. Notify your
security company of the communications failure.
If your telephone, internet, or cellular service is interrupted, your
security system cannot send reports to the security company
unless an alternate means of transmitting the reports exists.
For telephone communication, your security company can
program your security system to automatically disconnect the
telephones when sending reports to the security company. Once
the report finishes, the security system returns the telephones to
normal operation (check with your security company).
Consult with your installer to determine if your security system is
configured with a communicator delay. A communicator delay
aborts reports to your security company if the control panel is
disarmed within 30 to 45 seconds after a burglary alarm is
triggered. Note that fire-type alarms are always reported without
a delay.
20
en | How the system reports events Control Panels
2015.01 | 02 | F.01U.307.371 Bosch Security Systems, Inc.
To Next Page
Loading...
