© Bosch Sensortec GmbH 2023 | All rights reserved, also regarding any disposal, exploitation, reproduction, editing, distribution, Document number: BST-BME280-DSxxx-yy
as well as in the event of applications for industrial property rights
▪ ℃
▪ ℉
▪ K
4.2 Default View
To reset the DD2.1 UI homepage to its default view, go to Panels->Default View, or click Ctrl+V.
4.3 Memory Map
▪ Memory map is used to launch the binary view of the sensor.
▪ This view contains information on all sensors and their respective addresses.
▪ To launch Memory Map, go to Panels -> Memory Map, or click Ctrl+M. The following window appears:
▪ To configure sensor values, click Write.
▪ To read the current register settings on the sensors, click Read.
Note: This option is disabled when the sensor is streaming data.
To Next Page
Loading...
