Buttons en
25
Buttons
8 Buttons
Buttons
The selection of programme settings depends on the programme that is set.
Button Selection Description
(mains
switch)
¡ Switch on
¡ Standby mode
¡ Restart the appli-
ance
Switch on the appliance or put it in
standby mode.
If the control panel does not respond,
press and hold for approximately
5seconds to restart the appliance.
→"The appliance is not working.",
Page50
Multiple selection To change a setting, press the or
selection button until the display
shows the required setting.
- 90 Adjust the temperature.
Set temperature in °C.
- 1400 Adjust the spin speed or deactivate
the spin cycle.
Set spin speed in rpm.
If is selected, the water is drained
and the spin cycle is deactivated. The
laundry stays wet inside the drum.
¡ Start
¡ Cancel
¡ Pause
Start, cancel or pause the pro-
gramme.
Finish in Up to 24 hours Set the programme end time.
The programme duration is already in-
cluded in the set number of hours.
Once the programme has started, the
programme duration is displayed.
Options ¡ Displaying or hiding
additional buttons
¡ If you briefly press the button, you
can display or hide additional but-
tons.
→"Displaying or hiding additional
buttons", Page21
Options Multiple selection
→"Basic settings", Page40
Speed Per-
fect
¡ Activate
¡ Deactivate
Activate or deactivate a shorter pro-
gramme duration.
Note:Energy consumption increases.
The washing result is not affected by
this.