en Basic operation
34
▶ Press and hold Favourite for ap-
prox. 3 seconds.
Press Favourite to call up the
saved programme.
Note:To overwrite the saved pro-
gramme, repeat the steps above.
13.5 Opening the door
1. Press on the edge of the door.
2. Open the door.
13.6 Loading laundry
Note:To prevent creasing, note the
maximum load for the programmes.
→"Programmes", Page28
Requirements
¡ The laundry is prepared and sor-
ted.
→"Laundry", Page32
¡ The drum is empty.
1. Open the door.
→"Opening the door", Page34
2. Place the laundry in the drum.
3. Close the door.
Ensure that there is no laundry
trapped in the door.
13.7 Starting the programme
Note:If the intelligent dosing system
is activated, make sure that the dis-
pensers have been filled →Page36
and the basic dosage has been set
→Page37.
Requirement:A programme is set.
→"Setting a programme", Page33
▶ Press .
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows the programme
duration or the programme end
time.
a After the programme has ended,
the display shows: "End".
13.8 Adding laundry
After the programme starts, you can
remove or add laundry depending on
the programme status.
1. Press .
During the washing cycle, the ap-
pliance pauses.
During the drying cycle, the appli-
ance checks whether it is possible
to add laundry.
Note:If you want to add laundry,
follow the instructions on the dis-
play.
→"Display", Page24
2. Open the door.
→"Opening the door", Page34
3. Add or remove laundry.
4. Close the door.