Troubleshooting en
57
Fault Cause and troubleshooting
The programme dura-
tion changes during
the wash cycle.
Foam detection system switches on a rinse cycle if
foam build-up is too high.
▶ Not a fault – no action required.
Drum jerks after the
programme starts.
This is caused by an internal motor test.
▶ Not a fault – no action required.
Fluff on the laundry. Fluff has accumulated in the drum.
▶ Run the Cottons90°C programme without any
laundry or detergent.
The laundry is too
damp.
Unsuitable programme for the type of fabric.
There has been a power cut.
▶ Check whether the lighting in your room or other
appliances are working.
The load is too large.
After the end of the programme, warm laundry feels
damper than it actually is.
1. Remove the laundry from the drum as soon as the
drying programme has finished.
2. Spread the items of laundry for cooling.
Drying target not adjusted.
Load too small.
Water tap is closed during the drying phase.
▶ Make sure that the water tap also remains open
during the drying phase.
The ambient temperature is greater than 30°C.
▶ Ensure that the ambient temperature is below 30
°C.
Insufficient air circulation at the appliance's installation
location.
▶ Ventilate the appliance's installation location.
The water pressure is low.
No remedial action possible.
Laundry is not spun sufficiently.
▶ Always select the highest possible spin speed for
the washing programme in question.
Thick and multi-layered fabrics require a longer drying
time.
▶ Set a timed programme for the subsequent drying.
→"Programmes", Page28
To Next Page
Loading...
Need help?
General