Bosch CSG656B 2B Series User Manual

Troubleshooting en
47
Fault Cause and troubleshooting
"E:30 / -80" ▶ Ensure that the drain pipe and water drain hose are
not kinked or trapped.
The water outlet hose is connected too high.
▶ Install the water outlet hose at a maximum height of
1 metre.
Unapproved extension installed on the water drain
hose.
▶ Remove any unapproved extensions from the water
hose.
→"Connecting the appliance", Page15
Detergent dosage is too high.
▶ Immediate measure: Mix one tablespoon of fabric
softener with 0.5 litres of water and pour the mix-
ture into the compartment for manual dosing (not
for outdoor clothing, sportswear or items stuffed
with down).
▶ If intelligent dosing is activated, reduce the basic
dosage. →Page37
▶ If you dose manually, reduce the amount of deter-
gent for the next washing cycle with the same load.
"E:36 / -25 / -26" Drain pump is blocked.
▶
→"Cleaning the drain pump", Page43.
"H:32" The unbalanced load detection system has interrupted
the spin cycle because the laundry is unevenly distrib-
uted.
▶ Redistribute the laundry in the drum.
Note:Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
"E:30 / -10" and/or The water pressure is low.
No remedial action possible.
The filter in the water inflow is blocked.
▶ Clean the water inflow filter.
The tap is turned off.
▶ Turn on the tap.
The water inlet hose is kinked or jammed.
▶ Ensure that the water inlet hose is not kinked or
jammed.

Bosch CSG656B 2B Series Specifications

General

Brand	Bosch
Model	CSG656B 2B Series
Category	Oven
Language	English