en Troubleshooting
50
Fault Cause and troubleshooting
Creasing. ▶ Set the suitable programme for the type of fabric.
Easy-Care fabrics are dried for too long.
The appliance is not
working.
The mains plug of the power cord is not plugged in.
▶ Connect the appliance to the power supply.
The circuit breaker in the fuse box has tripped.
▶ Check the circuit breaker in the fuse box.
There has been a power cut.
▶ Check whether the lighting in your room or other
appliances are working.
There is a software fault.
▶ To restart the appliance, press and hold for ap-
proximately 5seconds.
The programme does
not start.
has not been pressed.
▶ Press .
Door is not closed.
▶ Close the door.
Childproof lock is activated.
▶ Deactivate childproof lock.
→"Deactivating the childproof lock", Page36
Finish in is activated.
▶ Check whether Finish in is activated.
→"Buttons", Page25
Laundry is caught in the door.
▶ Remove any trapped laundry.
The pump for the intelligent dosing system is blocked.
1. Put the appliance into standby mode.
2. Clean the pump unit.
→"Cleaning the detergent drawer", Page41
3. Switch the appliance on.
4. If the display appears again after cleaning the
pump unit, or the programme cannot be started,
call customer service.
→"Customer Service", Page60
Note:You can deactivate and manually dose the intel-
ligent dosing system until the fault is rectified.
The detergent drawer has not been pushed in fully.
▶ Push in the detergent drawer until the symbol goes
out.
To Next Page
Loading...
Need help?
General