Basic operation en
33
¡ Do not use dyes regularly as fixing
salt can damage stainless steel
¡ Do not use color-bleaching agents
in the appliance
¡ Do not pour vinegar into the dis-
pensers →Page36 of the intelli-
gent dosing system
Basic operation
13 Basic operation
Basic operation
13.1 Switching on the appli-
ance
Note:If you switch the appliance on
the first time after you have connec-
ted it to the electrical system, the
switch-on process takes up to one
minute.
Requirement:The appliance has
been correctly installed and connec-
ted.
→"Installation and connection",
Page13
▶ Press .
The switch-on process takes a few
seconds.
a An audible function test is carried
out.
Note:The lighting for the drum goes
out automatically.
13.2 Setting a programme
1. Press the required programme.
→"Programmes", Page28
2. If required, adjust the programme
settings. →Page33
13.3 Adjusting the pro-
gramme settings
Requirement:A programme is set.
→"Setting a programme", Page33
▶ Adjust the programme settings.
→"Buttons", Page25
Observe the information about op-
erating logic →Page20.
Notes
¡ The programme settings are not
saved permanently for the pro-
gramme.
¡ The setting is saved if you activate
or deactivate the intelligent dosing
system.
13.4 Saving the programme
settings
You can save your individual pro-
gramme settings as favourites.
Requirements
¡ A programme is set.
→"Setting a programme",
Page33
¡ The programme settings have
been adjusted.
→"Adjusting the programme set-
tings", Page33