Charger
The Charger (DCNM-WCH05) is used for (and can be used for connection to IT power
distribution systems):
– Charging the Battery Pack (DCNM-WLIION).
– One Charger can charge a maximum of 5 Battery Packs at the same time.
Scope of delivery
– The DCNM-WCH05 is shipped with the following parts:
– 1x Mains power cable.
– 1x Loop‑through mains power cable.
– 1x Mounting bracket.
– 1x Safety instructions.
Figure 6.6: Charger DCNM-WCH05
Item
Description
1 Ventilation grilles: Do not obstruct the ventilation grilles. The Charger must
remain within the specified temperature range. See Charger (DCNM-WCH05),
page 37.
2 Battery Pack container (5x): Each container could hold a Battery Pack (DCNM-
WLIION).
3 Charging level LEDs: Shows the charging level of the Battery Pack: From left to
right (5‑1), typical each LED indicates a capacity time in hours (left):
– LED 5: 18‑20
– LED 4: 13‑18
– LED 3: 8‑13
– LED 2: 3‑8
– LED 1: <3
NOTE: The accuracy of the Battery Pack remaining capacity is +/- 20%.
NOTE: It can take up to 1 minute before the first LED is lit.
6.3
DICENTIS Installation Wireless Devices and Accessories | en 25
Bosch Security Systems B.V. Installation Manual 2015.03 | V1.01 |
To Next Page
Loading...
