Bosch Diniop IP - NWC-0455 - Connections; Power Connection; Network and PoE Connection

EN | 16
Bosch Security Systems | 2006-05 | V2.0
Dinion IP | Installation Manual
Connections 2
Power
Caution
Ensure that your power supply matches the rated voltage of your camera
before installing.
Caution
Never supply power via the power connector when power is supplied via
the Ethernet connection (PoE).
Network (and power)
Caution
Never supply power via the Ethernet connection (PoE) when power is
supplied via the power connector.
VIDEO
D
C
12V
AC
24V
ALARM
ETH
10mm
• use a class 2 power supply
• 24 VAC or 12 VDC
• push in the tabs to open the quick-connectors
(these connections are not polarity sensitive).
• use AWG16 to 22 stranded wire or AWG16 to
26 solid wire; cut back 10mm (0.4") of
insulation.
VIDEO
DC
1
2
V
AC
2
4
V
ALARM
ETH
UTP Cat 5 RJ45
• connect the camera to a 10/100 Base-T
network.
• use a shielded UTP Category 5 cable with
RJ45 connectors.
• Power can be supplied to the camera via the
Ethernet cable compliant with the Power-over-
Ethernet (IEEE 802.3af) standard.