EN | 52
Bosch Security Systems | 2006-05 | V2.0
Dinion IP | Installation Manual
Target LU N
Enter the LUN of the required drive.
Target password
If the drive is password protected, enter the password.
Note
You may not enter a new password. This is only possible by configuring
the iSCSI storage device.
Initiator name
The initiator name is automatically displayed after a connection has been
established.
Initiator extension
Enter the initiator extension. For the sake of clarity, you can enter a name or the
existing extension with a comment, for example "– Camera 2"
Decoupling the drive used
Each drive can only be associated with one user. If a drive is already being used
by another person, you can decouple the drive and connect the drive with the
NWC-0495.
• Double-click a drive that is already being used in the LUN map. You will see
a warning message.
• Confirm the decoupling of the current user. The drive is released and can be
connected to the NWC-0495.
Storage information
The status of the currently selected storage medium and the data throughput are
displayed here for information. You cannot change any of these settings.
To Next Page
Loading...
