DIVAR IP all-in-one 6000 Maintenance | en 17
Bosch Security Systems B.V.
User manual
2022-10 | V01 | F.01U.408.604
7 Maintenance
7.1 Signing in to the administrator account
Signing in to the administrator account in BVMS operation mode
To sign in to the administrator account in BVMS operation mode:
1. On the BVMS desktop, press CTRL+ALT+DEL.
2. Press and hold the left SHIFT key immediately after clicking Switch User.
3. Press CTRL+ALT+DEL again.
4. Select the BVRAdmin user and enter the password that was set during the system setup.
Then press ENTER.
Note: To go back to the BVMS desktop, press CTRL+ALT+DEL and click Switch user or Sign
out. The system will automatically go back to BVMS desktop without a system restart.
Signing in to the administrator account in VRM or iSCSI operation mode
To sign in to the administrator account in VRM or iSCSI operation mode:
4 On the Windows sign-in screen, press CTRL+ALT+DEL and enter the BVRAdmin password.
7.2 Monitoring the system
7.2.1 Monitoring the system using the SuperDoctor application
The DIVAR IP all-in-one systems come with the pre-installed application SuperDoctor, which
you can use to monitor your system.
Activating the monitoring functionality
To activate the monitoring functionality:
1. Sign in to the administrator account (refer to
Signing in to the administrator account,
page 17
).
2. On the desktop, in the Tools folder, right-click the startSD5Service script, and then click
Run with PowerShell.
3. Double-click the SuperDoctor 5 Web icon on the desktop.
4. Sign in to the web interface using the following default credentials:
– User name: admin
– Password: DivaripSD5
5. Click the Configuration tab, and then click Account Setting and change the default
password.
Note: Bosch strongly recommends to change the default password immediately after the
first sign-in to the SuperDoctor application.
6. Under the Configuration tab, click Alert Configuration.
7. Activate the SNMP Trap feature and specify the IP address of the receiver for SNMP
traps.
Deactivating the monitoring functionality
To deactivate the monitoring functionality:
1. Sign in to the administrator account (refer to
Signing in to the administrator account,
page 17
).
2. On the desktop, in the Tools folder, right-click the stopSD5Service script, and then click
Run with PowerShell.
7.2.2 Monitoring the system using the IPMI interface
DIVAR IP all-in-one 6000 has a dedicated IPMI port on the rear side.
You can use the IPMI interface to access, monitor, diagnose, and manage your DIVAR IP all-in-
one 6000 system as a remote server.
To Next Page
Loading...
Need help?
General
