Bosch FW 200 - Page 29

6 720 643 256 (2010/05)
Operation | 29US/CA
B Press the dial , the display changes to
the Vacation menu and Start is selected.
Now you can enter the date on which you want
the vacation program to start. Enter the year,
month and day one after the other and
confirm your entry in each case by pressing
the dial .
B Turn the dial so that End is selected.
B Press .
Now you can enter the date on which you want
the vacation program to end. Enter the year,
month and day one after the other and
confirm your entry in each case by pressing
the dial .
Programming of the vacation program is now
complete. If required, you can adjust the heating
and domestic hot water modes. The following
operating modes are set in the factory settings:
• Heating circuit 1: Operating mode Frost .
• Heating circuit 2: Operating mode Frost .
• Domestic hot water: Operating mode Off
1)
or 60 °F (15 °C)
2)
.
• DHW recirculation pump: Off mode.
• Thermal disinfection: Off mode.
When the vacation program is active, the
standard display shows and the dates, e.g.
VACATION UNTIL 09/30/2010 (30.09.2010).
To cancel the vacation program early:
B Select menu option Vacation > Start.
B Press the dial and then press .
The display shows --/--/---- (--.--.----).
B Press the dial to store the setting.
If you have set the vacation
program to start on today's date, it
will start immediately. If the date is
in the future, the vacation program
will start at 12:00am (00:00) on the
set start date.
It will end at 11:59pm (23:59)
hours on the set end date.
1) DHW heating with combi boiler
2) DHW heating via hot water tank