6 720 643 256 (2010/05)
Menu settings INSTALLER SETTINGS (for installers only) | 57US/CA
8 Menu settings INSTALLER SETTINGS
(for installers only)
Moving through menu structure, programming,
deleting values and reverting to the default
setting are described in detail in section 5.2 from
page 23.
8.1 INSTALLER SETTINGS menu
summary and settings
The tables set out below provide
• an overview of the menu structure (column 1).
The menu depth is identified by various
shades of gray.
E. g. in the Heating parameters menu the
submenus Heating circuit 1, Heating
circuit 2, Minimum outdoor temperature and
Building storage capacity are on the same
level.
• an overview of the factory settings (column 2),
e.g. for the purposes of resetting individual
menu options to the factory settings.
• an overview of the adjustment ranges of the
individual menu options (column 3).
• space for making a note of your personal
settings (column 4).
• references to the detailed descriptions of the
individual menu options (column 5).
The INSTALLER SETTINGS menu is
intended only for installers.
B To open INSTALLER SETTINGS:
press and hold for approx.
3 seconds.
menu
The menu options are only shown if
the system components are present
and/or active and if no remote
control is accessing these. Some
menu options are not shown
because they are switched off by a
setting for another menu option.
B Always set or skip menu options
in order. In that way, subsequent
menu options will be
automatically adjusted or not
shown.
To Next Page
Loading...
