Bosch FW 200 - Test of the Actuators on the System

6 720 643 256 (2010/05)
Menu settings INSTALLER SETTINGS (for installers only) | 85US/CA
8.10 Test of the actuators on the
system
INSTALLER SETTINGS: Output test
The Output test menu gives you the opportunity
to activate individual actuators (pumps, mixing
valves) individually to check their function.
• Stop all output tests: Use this parameter to
reset the activation of all actuators to Auto.
• Pump, heating circuit 1:
– Auto: Control of the pump according to the
set program
– Manual ON: Pump always on
– Manual OFF: Pump off
• Pump, heating circuit 2: See above under
Pump, heating circuit 1
• Mixer, heating circuit 1:
– Auto: Control of the mixing valve according
to the set program
– Manual 100 % open: Mixing valve in open
position
– Manual 50 % open: Mixing valve in middle
position
– Manual 0 % open: Mixing valve in closed
position
• Mixer, heating circuit 2: See above under
Mixer, heating circuit 1
• Tank charge pump: See above under Pump,
heating circuit 1
• DHW recirculation pump: See above under
Pump, heating circuit 1
For menu structure and adjustment range
Æ page 65.
As long as one or several actuators
are activated manually, a
corresponding message will be
shown on the display.