Bosch FW 200 - Heating Circuit Parameters

6 720 643 256 (2010/05)
68 | Menu settings INSTALLER SETTINGS (for installers only) US/CA
8.3.2 Heating circuit parameters
Menu: Heating parameters > Heating circuit 1 ...
Heating circuit 2
• Heating circuit type: Use this menu option to
set the heating type for the Heating circuit 1
and/or Heating circuit 2:
– Baseline/Design temp: Default settings for
a level heating curve are used according to
the classic base point/end point method.
– Radiant Floor: Default settings for an
uneven heating curve as in a radiant floor
heating circuit are used.
– Radiators: Default settings for an uneven
heating curve as in a radiator heating
circuit are used.
– Baseboard: Default settings for an uneven
heating curve as in a convector heating
circuit are used.
For menu structure and adjustment ranges
Æ page 58.
Parameters not used in a particular
type of heating are not shown.