Bosch FWA 43 Series - Adjustment Program (Calibration); Save User Individual Data

1 690 326 006 2008-8-25| Robert Bosch GmbH
Operating System-Software | FWA 43xx / 44xx | 39 en
Adjustment program (Calibration)14.6
Function
Track adjustment
R
Camber adjustment R
Level adjustment R
Follow the screen instructions for the corresponding i
adjustment step.
When must an adjustment executed?
If there is a suspicion that the displayed measuring
R
values of the wheel alignment gauge is not correct.
If the error message "Device is out of tolerance" is
R
displayed permanently.
1
)
In case of maintenance of the wheel alignment
R
gauge.
1) As long as the wheel alignment gauge is provided with a 8 sensor
measuring system, a constant electronic separate check of the
measuring accuracy takes place automatically, which triggers the
error message "Device is out of tolerance" in case of complaints.
Save user individual data14.7
Customer data and measuring protocol14.7.1
The customer data and the measuring protocol is
i
saved in the following folder:
Path
C:\<program files>\FWA-CCD\WheelAligner\Aligner\
¶
General\database
Measurement report14.7.2
The measuring protocol is saved in the folder:
i
Path
C:\<program files>\FWA-CCD\Wheel Aligner\Aligner\
¶
General\protocol
Automatically created vehicle data14.7.3
The automatically created vehicle data is saved in
i
the folder:
Path
C:\<program files>\FWA-CCD\WheelAligner\Aligner\
¶
Targetdata\User
Breakdown of toe camera long:Fig. 4:
Breakdown of camber cameraFig. 5:
The breakdown of an camber camera is displayed R
through transverse bars like in case of track camera.
The localisation of the error is basically simple
R
proportionately to the track camera, as the error are
always located in case of displayed camera.
Breakdown of Fig. 6: Steering axis inclination camera