1 690 326 006 2008-8-25| Robert Bosch GmbH
Operating System-Software | FWA 43xx / 44xx | 45 en
The fields in the display blocks has the following
significance:
Fields Legend
ID Does not have any significance in case
of KP and CPs and determines the
position in the vehicle in case of MPs:
"1" = front to the left
"2" = front to the right,
"3" = behind to the left,
"4" = behind to the right
Software Displays the included Firmware version.
Serial No. Display the serial number of the equipment.
Part No Display the EDV number of the equipment.
Fab Date Displays date of manufacture.
Version Displays the equipment version.
Radio Channel Displays the set radio channel.
PLD Displays the version of the PLD
(Programmable Logical Device).
Calib Data Displays the date of last calibration.
Fields in the display blocksTab. 5:
The channel number is smaller by 1 then the number i
displayed in the CCD server. Example: Radio Channel
"0" is displayed as channel "1" on the CCD server.
Functions called via "Actions"14.9.4
Options Legend
Reconnect It is searched for the
connected equipments in
the selected interface.
Reset Unit The measuring box shall be
reset. This function should be
executed in case individual
sensor are not found.
Does not have function in
case of LAN interface.
Switch off the sensorheads Connected radio sensor
are deactivated.
Clear data fields Deletes all fields in
the display blocks.
Print Preview... Page view.
Print... Printer
Write Sensorhead Version Is available only in
Service variants
Writes the content of
the field "Version" in the
EEPROM of the selected
measuring processors.
OptionsTab. 6:
Register card "Light exposure"
CCD line and transmitter-LED must be configured
optimally for exact measurement and must match.
The parameter used for it can be displayed here and if
required can be modified.
The parameters are saved in communication processor
and in the measuring processor and is displayed in
different display blocks (compare colour scheme in
case of "Type and version info") and should be changed
only after consultation.
CQ = camera transverse track, CL = camera
i
longitudinal track):
Significance of the fields in the display blocks14.9.5
Options Legend
CQ0CL0 Transmitter power for
level 0 (adjustment).
CQ1CL1 Transmitter power for
level 1 (short interval).
CQ2CL2 Transmitter power for level
2 (medium interval).
CQ3CL3 Transmitter power for
level 2 (big interval).
Current main level Currently used
transmitter power.
Current left level Currently used transmitter
power of the left transceiver
diode (if present).
Current right level Currently used transmitter
power of the right transceiver
diode (if present).
CQ Toe ShutterCL Toe Shutter Exposure time of the
CCD sensor (Track).
CQ Camber LEDCL
Camber LED
Illumination and transmitter
time of the camber LED.
CQ Camber Shutter
CL Camber Shutter
Exposure time of the
CCD sensor (camber).
Threshold Rejection threshold.
Avoiding image noise
through weak signals.
Fields in the display blocksTab. 7:
The functions that be called via "Actions" are i
identical to the tab "Type and version info".
To Next Page
Loading...
