1 690 326 006 2008-8-25| Robert Bosch GmbH
Operating System-Software | FWA 43xx / 44xx | 41 en
Version check in case of Flashwriter14.8.5
The version check takes place after the begin and
i
execution of the Firmware update.
1 Description of the equipments and the components
2 Status of the components:
yellow button: a new Firmware is available on the PC, as in the
version of the component.
green button: The Firmware available on the PC is identical with the
version included in the component or the older one.
red button: The equipment and/or the component is not connected
or cannot be selected.
red line: The component cannot be updated due to technical
restrictions.
3 Version of the Firmware included in the component.
4 Version of the Firmware available on the PC.
5 Symbol for cable operation.
After updating the Firmware, a green status button i
should be displayed for all the components:
Update of the communication processor14.8.6
The communication processor shall be updated and 1.
the result shall be displayed.
The step is executed only if the communication 2.
processor can be updated and the firmware file
receives a current version as already existing or the
version check is deactivated.
Update of the measuring processors14.8.7
The measuring processors of all the connected 1.
sensor are updated one after the other and the
result is displayed.
The step is executed only if the respective measuring 2.
processor can be updated and the firmware file
receives a current version as the one already existing
in the equipment or the version check is deactivated.
Changes are not executed (Keystrokes, cable
i
plugged / unplugged or similar) in the connected
equipments, as long as data transfer takes place. A
continuous data transfer is signalised by flashing all
LEDs in the operation field of the sensor.
To Next Page
Loading...
